Tukang Las Titik Baterai Polimer

 

Lithium Polymer Battery Tab and 10-120 Layers Foil Spot Welding Welder Machine

 

 

 

 

	TOB-USW-8000W
	8000W
	20KHZ
	220V/ 50Hz
	Greater than or equal to 0.5MPa
	20 mm
	0.05-9S
	1. Ceramic sheet: German imported black film 2. Aluminum rod: American Aluminum Corporation 3. Welding head: powder alloy

	①10~120 layer aluminum foil + 0.2-0.6mm pure aluminum tab welding, welding spot 4*6 / 4*8 / 4*10mm / 5*30mm
	②10~120 layer copper foil + 0.2-0.6mm nickel or copper nickel plated tab welding, welding spot 4*6 / 4*8 / 4*10mm / 5*30mm
	③0.2-0.6mm nickel or nickel-plated copper tab, can weld with 10~90 layers of copper foil, welding spot 4*6 / 4*8 / 4*10mm
	④0.2-0.6mm aluminum tab, can weld with 10~90 layers of aluminum foil, welding spot 4*6,4*8,4*10mm
	⑤0.2-0.6mm aluminum tab or nickel tab 2~12 layers welding, welding spot 4*6mm
	⑥{{0}}.2-0.6mm aluminum strip and 2.0mm aluminum plate welding

 

1.1 Controller: The circuit adopts international advanced full-bridge voltage regulator circuit and is optimized to achieve constant amplitude output and automatic frequency tracking without manual adjustment. Adopt intelligent control mode, covering modes such as time, energy, power, energy and depth.

1.2 the welding head is made of imported powder alloy steel, high hardness, the pattern is made of high precision grinding, the service life is very long, 13-15 million times on one side.

1.3 ultrasonic under the sound pole, strict selection of imported special mold steel, wear resistance, high temperature resistance, good toughness, high mechanical rigidity, small deformation after heat treatment, so the ultrasonic output frequency consistency is high, the mechanical high frequency displacement amplitude is large, strong, stable.

1.4 welding effect: welding is firm, low internal resistance, no soldering, no vibration powder, no burning diaphragm, no hot insulating rubber, no cracking pole piece, the residual welding surface between metal and metal is more than 80%. The surface after welding is flat, no wrinkles, no burrs on the back, the solder joints are full and clear, firm and reliable, the solder joints are not broken, and the tensile strength can be tested according to different layers and materials.

1.5 7-inch anti-jamming touch display, bilingual in Chinese and English, friendly interface, easy to operate, with the following parameters can be set: trigger time, welding time, power, secondary wave delay time, real-time display frequency and welding power to ensure welding Effect, fault type alarm, etc.

1.6 boot automatic detection function: the welder has a power-on self-test detection function, scan welding system parameters and display in real time, if there is a fault, issue an alarm prompt to avoid working under fault conditions.

1.7 Welding quality data auxiliary function: According to the real-time welding data parameters, the upper and lower amplitudes of the welding parameters can be set to monitor the quality of each welding product, and the upper and lower amplitudes are biased, and the equipment will alarm.

1.8 Amplitude automatic compensation function: The welding machine has automatic amplitude compensation function, which can automatically adjust the amplitude output to make the amplitude output more stable, improve the welding stability and ensure the consistency of welding quality.

 

 

 

 

 

 

Tag populer: